TOGGLER® Combo Kits

SnapSkru: 

1. Press tip of SnapSkru anchor into drywall using screwdriver or screw gun. Drive anchor clockwise into drywall until anchor stops flush with wall.
2. Place item over anchor and insert screw
3. Tighten screw flush with item. The screw POPS open the anchor locking in on the wall and holding the gypsum board in compression. This reinforces the wall, increasing its holding power significantly.

TOGGLER:

1. Drill 5/16” diameter (Ø 8mm) hole. Fold anchor in the middle.
2. Insert anchor in hole and tap flush with wall.
3. Insert key to pop anchor open and lock behind hollow wall. Do not force key. Not necessary for thick or solid walls.
4. Place item over anchor. Insert screw and tighten until screw is flush with fixture. 

ALLIGATOR:

Solid Wall Installation

1. Drill hole into wall the same diameter as anchor, at least 2x the length of the anchor. Push in anchor and tap flush to wall with a hammer.
2. Place item over anchor, insert screw, and tighten flush with item. For best results, use a screw gun.

Hollow-Wall Installation

1. Drill hole into wall the same diameter as anchor, at least 2x the length of the anchor. Push in anchor and tap flush to wall with a hammer.
2. Place item over anchor. Insert screw and tighten flush with item.

Not recommended for hollow ceilings. Instead, use our Toggler^® Plastic Anchor or our SNAPTOGGLE^® Toggle Belt.  

SNAPTOGGLE:

Solid Wall Installation

1. Drill hole into wall the same diameter as anchor, at least 2x the length of the anchor. Push in anchor and tap flush to wall with a hammer.
2. Place item over anchor, insert screw, and tighten flush with item. For best results, use a screw gun.

Hollow-Wall Installation

1. Drill hole into wall the same diameter as anchor, at least 2x the length of the anchor. Push in anchor and tap flush to wall with a hammer.
2. Place item over anchor. Insert screw and tighten flush with item.

Not recommended for hollow ceilings. Instead, use our Toggler^® Plastic Anchor or our SNAPTOGGLE^® Toggle Belt.