Wood

1. Mount the Universal Steel & Wood Socket Drive (Part No. HTWSST) into the chuck of the drill.
   NOTE: Certain types of wood truss/wood joint require pre-drilling with a 1/8” diameter bit
2. Insert the head of the anchor into the socket driver.
3. Press the tip of the anchor against the wood surface [or press tip into pre-drilled hole, if needed].
4. Install with a smooth, steady motion until the anchor is firmly seated against the wood.
5. Thread the appropriate diameter steel threaded rod or threaded bolt into the anchor. The threaded rod or bolt should fully engage the thread length of the anchor.

Steel

1. Mount the Universal Steel & Wood Socket Drive (Part No. HTWSST) into the chuck of the drill.
2. Insert the head of the anchor into the socket driver.
3. Press the tip of the anchor against the steel surface and install with a smooth, steady motion until the anchor is firmly seated against the steel. No pre-drilling is required.
4. Add the retainer nut [if needed].
5. Thread the appropriate diameter steel threaded rod or threaded bolt into the anchor. The threaded rod or bolt should fully engage the thread length of the anchor. 

Concrete

1. Use the correct size masonry drill and drill the hole at least one anchor diameter deeper than the calculated embedment depth. Clean the hole using a nylon brush and compressed air.
2. Select the appropriate size socket driver (Part No. HTCST14, HTCST38 or HTCST12) and mount it into the chuck of the drill.
3. Insert the head of the anchor into the socket driver.
4. Press tip into pre-drilled hole and install with a smooth, steady motion until the anchor is firmly seated against the concrete.
5. Thread the appropriate diameter steel threaded rod or threaded bolt into the anchor. The threaded rod or bolt should fully engage the thread length of the anchor.