Wej-Con™ Concrete Screws — Hex Washer Head - TAPCON

1. Use the correct size masonry drill bit (one included in every box) and drill the hole at least 1/4" deeper than the calculated embedment depth.
   It is recommended that a minimum of 1" and a maximum of 1-3/4"

2. Clean the hole using a nylon brush and compressed air.
3. Place the anchor point through the fixture into hole.
4. Drive the anchor in a single continues motion until the anchor is set firmly against the fixture.

NOTE: Always wear safety glasses. Normal safety precautions should be observed when drilling the holes to avoid electrical installations, other utilities and reinforcement bars.